Naarva grapple ready for work:
Suitable for:
Felling and cross-cutting individual trees
Pruning standing trees before felling
Clearing bushes and verges
Loading:
Cut, stack and load
The Naarva felling head is easy and quick to connect in place of the tractor's own timber grapple. It can be used to fell, cross-cut and efficiently load trees, bushes and branches.
Powerful guillotine cutting:
Despite its low weight, the felling head easily cuts trees up to 23 cm thick (25 cm for softwood). The jaws grip the tree and a separate cutting cylinder pushes the blade through the tree with a force of 95 kN. When not in use, the guillotine blade remains protected inside the housing, where it does not interfere with loading trees.
Using the tilt cylinder, the felling head can be easily and controllably turned from the felling position to the loading position. As the guillotine blade is inside the housing during loading, it does not interfere with loading in any way.
Controlled from a switch unit installed in the tractor cab (dedicated grapple controller).
Technical data
Weight without rotator approx. 180 kg
Height in felling position approx. 70 cm
Grapple / collecting jaw opening approx. 45 cm
Cutting diameter, force and speed * Max. cutting diameter: Ø23 cm Cutting force: 95 kN Cutting time: 1.8 s
Required pressure 170–200 bar
Required oil flow 40–70 l/min
Control system Cable control with 3 buttons
Voltage 12 V or 24 V. Used on a tractor with a 12 V system.
With hard wood species (oak, beech, etc.), the maximum cutting diameters are approximately 30% smaller. * With an oil flow of 55 l/min. The stated values are indicative. The manufacturer reserves the right to make changes. 04/2011.
Cutting blade replaced.