Toyota forklift mast for tractor mounting., Salo

A forklift mast from a Toyota electric forklift adapted for a tractor three-point linkage, mountable either to the rear lift or to the front. It could also be fitted to a front loader or a small loader. Forks have manual lateral adjustment; forged-iron forks. Fork length 1,200 mm. Mast height only 2,050 mm, so it will fit through lower doorways. The mast is a low-lift type: it raises the forks to the top of the mast before the inner section extends, which also gives good visibility to the forks. The mast’s lifting capacity as a forklift was 2,000 kg (it will certainly take more). With the fixed forks the capacity is 2,500 kg. The mast raises the forks to 3,700 mm from the ground with the lift in the mid position (approx. 350 mm), so you can lift loads a bit higher. Forks can be fitted with a lifting cage for painting/renovation or other lifting tasks. Connected to a tractor it also allows you to reach tighter spaces to lift goods. Cylinders are dry and not leaking. Overall the mast is in tidy condition, a proper unit ready for service. The mast operates up/down on single-acting hydraulics, which are found on most tractors, so it suits both older and newer tractors, front or rear. The mast can be loaded onto a vehicle with a forklift free of charge when collecting. It transports well on car trailers when laid on its side and can be tipped onto a flatbed for collection. Collection times are very flexible, including evenings and weekends. There are no collection fees, and collection can be arranged without rush if needed.