Lot of 21 packs!!! Goodiy laminate 32 8 mm oak Saana 4V H2965, Pieksämäki

Lot of 21 packs of laminate on auction, including an additional pack used as samples. One pack covers 1.9948 m².

The laminate uses an easy-to-install Clic It locking system. Goodiy laminate has a usage class of 32. Goodiy Saana is a light, elegant floor. AC4, one-strip.

Dimensions: 129 x 19 x 0.8 cm. The product requires an underlay with a compression strength of CS ≥ 60 kPa.

LAMINATE OVERVIEW

The Goodiy laminate range includes designs suitable for classic, rustic and trend-conscious tastes. Laminate is easy to care for, hygienic, impact-resistant and—if maintained correctly—very durable. Because of the surface treatment, dirt stains do not adhere easily and can be removed with a damp cloth. A laminate floor withstands everyday wear well in families with children and in homes with pets. STRIP TYPE The number of strips affects the surface character: one- or two-strip laminate suits large floor areas, while three-strip gives a more expressive surface for smaller rooms.

USABILITY Laminate flooring is suitable for various interior spaces, except wet areas. Laminate is suitable for installation with both electric and water-based underfloor heating systems.

INSTALLATION METHOD The Clic It locking system means a floating laminate floor does not necessarily require a professional fitter, as the joint locks the board in place. The floor is equally simple to dismantle, since floating installation does not require glue.

INSTALLATION To install the laminate floor successfully, it is recommended to use at least the following tools: spacers, a tapping block, a fine-toothed saw or laminate cutter, a tape measure and square, pencil and hammer. Choose the underlay according to the subfloor. After installation the floor is immediately ready for use.

NOTE FOR INSTALLATION:

• Always read the detailed installation instructions supplied with the laminate before fitting.

• Suitable for installation with both electric and water-based underfloor heating systems.

• The subfloor must be clean, level, load-bearing and dry.

• Allow the packs to acclimatise at room temperature on a flat, ventilated surface for at least 48 hours.

• Room temperature must be at least 18 °C during installation.

• The temperature of a heated floor must not exceed 28 °C. The sample shown in the listing is indicative. Shade variations may occur between production batches.